Sat-Cable

Connect 32 Satellites with Diseqc switch 8×1 & 4×1

Hi,

This is the most only cheapest method available.

If you have up-to 8 satellites only then this setup is useful for you. Otherwise for 1-8 satellites you can use a simple Diseqc swtich 8×1 1.1.

**************SIMPLE / SHORT METHOD**************

1. Connect your LNB using a wire (RG6) to diseqc 4×1 to port 1 (LNB 1)

2. Connect another cable from diseqc 4×1 “out / receiver” to diseqc 8×1’s port / LNB 1 (as explained in the picture)

3. Connect another cable from diseqc 8×1 “tuner” to your STB

CCcam Panel - ?thumbnail=1

4. Open your STB settings > Menu > setup > tuners & scanning > tuner configuration

This is exactly how you have to configure the settings

CCcam Panel - ?thumbnail=1

This is it.

**************DETAILED METHOD**************

1. Connect your 1st LNB using a wire (RG6) to diseqc 4×1 to port 1 (LNB 1) (as explained in the picture)

2. Connect your 2nd LNB using a wire (RG6) to diseqc 4×1 to port 2 (LNB 2)

3. Connect your 3nd LNB using a wire (RG6) to diseqc 4×1 to port 3 (LNB 3)

4. Connect your 4th LNB using a wire (RG6) to diseqc 4×1 to port 4 (LNB 4)

5. Connect another cable from diseqc 4×1 “out / receiver” to diseqc 8×1’s port / LNB 1 (as explained in the picture)

6. Connect another cable from diseqc 8×1 “tuner” to your STB

CCcam Panel - ?thumbnail=1

4. Open your STB settings > Menu > setup > tuners & scanning > tuner configuration

This is exactly how you have to configure the settings

CCcam Panel - ?thumbnail=1

CCcam Panel - ?thumbnail=1

CCcam Panel - ?thumbnail=1

CCcam Panel - ?thumbnail=1

if you successfully configured first port (1) of diseqc 8×1 with 4×1 then you can easily configure rest of the ports 1 to 8.

8×4=32

Comments (412)

Comments are closed.

Panel Login

Login or register to manage your cccam clients . Registration is free and test lines are free .

d

Contact

Netherlands , EU

Telegram: @cccampaneleu